..s taktovanim som doteraz nemal ziadne skusenosti, za ten tyzden som sa troska otukal a dosku som konecne vcera nastavil a udrzal stabilne, ale iba na 3.2GHz s 1.13125 V, viac som nedal, pretoze mi vyskakovali chyby niekedy po hodine a niekedy mi z nicoho nic restartlo PC, prisiel som sem ci mi nemozte nejako poradit takymi pribliznymi hodnotami, iste neviete kolko presne..
..takze teraz drzim procak na tomto nastaveni(co tam nie je, je na AUTO):
Kód: Vybrať všetko
System Performance Settings:
- - - - - - - - - - - - - - - - - - - - -
AI OC Tuner: Manual
CPU Ratio: 8,5x
FSB Freq.: 377
PCIE Freq.: 100
FSB Strap to NB: 333
DRAM Freq.: 906MHz
DRAM Timing Cont.: Manual
5-4-4-12
DRAM Static Read Control: Enabled
___________________________
CPU Voltage: 1.13125V (CPU-z: idle - 1.112V, load - 1.128V)
CPU GTL 0/2: 0,610x
CPU GTL 1/3: 0,650x
CPU PLL Voltage: 1.52V
FSB Termination Voltage: 1.14V
DRAM Voltage: 1.90V
NB Voltage: 1.14V
SB Voltage: 1.10V
PCIE Sata Voltage: 1.50V
________________________
Load-Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU clock skew: auto
NB clock skew: auto
CPU Margin Enhancement: Optimalized
_______________________________
Advanced CPU configuration
- - - - - - - - - - - - - - - - - - - -
CPU Ratio: 8.5x
C1E Support: Enabled
Max CPUID VL: Disabled
Intel(R) Virtual. Tech: Enabled
CPU TM Function: Enabled
Execute Disabled bit: Enabled..ale ked chcem ist vyssie, tak musim spravit nieco zle..
..prosim o radu, chcel by som to dat aspon na 3.8GHz.. vdaka
